ExStar Hub 1.0.8-5 stuck at 98% optimizing network

Support
,
1

I just installed latest ExStar Hub 1.0.8-5. When clicking to optimize the network when scanner is connected over wifi, optimizing the network goes slow to 98% and it gets stuck there. I cannot do anything to get out of it, can’t cancel, can’t click on any other buttons, I can only shut down the program.

First, this getting stuck should not happen. Second, there should be a “Cancel” button. Third, any other buttons should still work.

2

Thank you for your valuable feedback regarding this issue. Yeah sure, we will optimize this in a short future and enhance the WIFI connection ability. For now you don’t need to click that “optimization” since the signal is already good to do the wireless scan.

3

then kindly remove the feature to optimize the network if it’s not needed.