Hello, appologies if this not the correct place in the forum for this but I am currently having some issues aligning multiple projects together and I am unsure why/what might be going on. There are 3 projects in this that need aligning together, project 1 and 2 align together without issues but project 3 will not align correctly at all (I have tried aligning project 3 before project 1 and 2 but it doesn’t help).
The auto alignment options were not giving me a good result so I tried using manual markers/features to align but it ends up looking like this example, I have tried using multiple various combinations of points (I have tried aligning with up to 32 selected) but the same ones just don’t get aligned to each other.
Here is an example of what happens if I try to align project 3 to 1 or 2 first.
The images show the most obvious parts of the alignment issues but it is present throughout, at this point I’m not sure If I am doing something wrong/misunderstanding the scanning process, or if there is some issue with the software.
Does anyone know what might be the problem or if there is a way for me to manually adjust the alignment of the projects?
Hi Nathan,
Thank you for sharing your case.
Looking at your screenshots, the main issue is that your alignment points are too close together and nearly in a straight line. On a long narrow part like yours, that leaves rotation poorly constrained—it looks aligned locally but drifts further out towards the ends.
A few things to try:
- Spread your points further apart. Pick points at both ends and the middle, not clustered in one spot. Different faces and heights help too.
- Double-check your point 3 in the second screenshot—it looks like it’s sitting right on the mesh edge, which can cause a bad pick.
- Make sure all markers are on the part itself, not on the table or supports. If the part moved between scans, background markers would fight against the ones on the part.
If you’ve already tried 32 well-spread points and it still won’t align, the part may have bent slightly between scans—long plastic parts can flex under their own weight depending on how they’re supported. In that case, realignment won’t fully fix it, and you’d need to rescan project 3 with the part supported the same way as the others.
Please try the suggestions below and feel free to discuss further with us: )
Thanks for the response, I have rescanned the object but this time I made sure it was stationary between scans. The alignment is much better now, it seems like in the last scan it was flexing when upside down which caused a fairly significant difference.
However the new scan still has some smaller alignment issues with markers that I’m not sure what the cause is.
The markers are only slightly misaligned but mean the generated mesh is out of alignment by quite a bit.